search

Klipper3d / klipper

Klipper is a 3d-printer firmware
GNU General Public License v3.0
9.55k stars 5.33k forks source link

BTT SKR E3 Turbo will not flash klipper #4806

Closed DragonFlyer007 closed 3 years ago

DragonFlyer007 commented 3 years ago

So brand new card, can not flash either marlin, klipper. I tried thru ssh with putty and kiuah, and also renaming .bin file and going thru micro SD. (with both psu power and only usb)

It does not flash and rename the .bin file on sd.

Thru ssh i will not flash either.

Also tried to flash new smoothie boothloader thru sd card, with nope. nothing there eiter.

Thru pronterface i run M115 and it says its Marlin 2.0 on it. (Factory install!?) Or did one of my attempts go thru here ? Can NOT recall seeing a .bin file being renamed on my sd card. Anyways, I need klipper.

Going crazy, any other ways to force a flash thru?

Thanks

DragonFlyer007 commented 3 years ago

After days of trail and error, i ended up starting from scratch, re-installed Octopi, and everything, then suddenly i was able to flash thru SD card with built .bin file thru KiauH. Not really sure why i suddenly would flash, because i tried a million thingss at once at one point, but all good now.