Open issy opened 6 months ago
for me it works but partially. I can not switch operation mode from command to event.
info 2024-02-12 06:37:53MQTT publish: topic 'zigbee2mqtt/0xdc8e95fffe15d77b', payload '{"linkquality":128,"state":"OFF"}' error 2024-02-12 06:38:09Publish 'set' 'operation_mode' to '0x6c5cb1fffe9a55c4' failed: 'Error: Write 0x6c5cb1fffe9a55c4/1 genOnOff({"tuyaOperationMode":1}, {"timeout":10000,"disableResponse":false,"disableRecovery":false,"disableDefaultResponse":true,"direction":0,"srcEndpoint":null,"reservedBits":0,"manufacturerCode":null,"transactionSequenceNumber":null,"writeUndiv":false}) failed (no response received (243))' info 2024-02-12 06:38:09MQTT publish: topic 'zigbee2mqtt/bridge/log', payload '{"message":"Publish 'set' 'operation_mode' to '0x6c5cb1fffe9a55c4' failed: 'Error: Write 0x6c5cb1fffe9a55c4/1 genOnOff({\"tuyaOperationMode\":1}, {\"timeout\":10000,\"disableResponse\":false,\"disableRecovery\":false,\"disableDefaultResponse\":true,\"direction\":0,\"srcEndpoint\":null,\"reservedBits\":0,\"manufacturerCode\":null,\"transactionSequenceNumber\":null,\"writeUndiv\":false}) failed (no response received (243))'","meta":{"friendly_name":"0x6c5cb1fffe9a55c4"},"type":"zigbee_publish_error"}'
I'm also experiencing the same issue. Registers fine in Z2M, but no events are emitted when button pressed or rotated.
Similar issue for me, I can use the single and double press buttons and also change operation mode using the 3 presses.
But I dont see any feedback when turning the knob.
What happened?
I paired my brand new tuya smart knob (ERS-10TZBVK-AA) to Zigbee2MQTT in Home Assistant. However, none of the attributes/actions are working. All show as unknown, and I get errors if I try to change the operation mode (the only value I can change for this device)
What did you expect to happen?
I expected to be able to use the button presses and knob rotations in zigbee2mqtt and home assistant. I've seen people on the hass forums saying that this device worked for them with zigbee2mqtt, and there is a herdsman adapter for it, so I assume that either my device is faulty or shipped with a different/newer firmware than devices that the adapter was tested with.
How to reproduce it (minimal and precise)
Zigbee2MQTT version
1.35.2
Adapter firmware version
6.7.8.0 build 373
Adapter
EZSP v8
Setup
Home Assistant on x86-64 baremetal
Debug log
No response