Moes switches ZS-B-EUX-XX-MS Missing functionality

jlpedrosa commented 6 months ago

What happened?

Switches: ZS-B-EU1-GY-MS from MOES (1 indicates number of rockers [1,3]) GY indicates color.

The device is connected to the network correctly, identified as Tuya TS003.

Issues found:

The device, according to the manual has support for 2 way configuration, which means the relay must be settable to "decoupled" mode, but it's not possible.
Unable to bind: I am not sure if this is an issue or not, but I was not able to bind the switch to a bulb (Ikea) for on/off. The UI disables it. There are 3 clusters reported on the UI, but on the enpoints there are 6 listed: 1,2,3,left,center,right, I tried all combinations.

What did you expect to happen?

Be able to configure the switch in "decoupled" mode. Be able to create bindings (unsure)

How to reproduce it (minimal and precise)

Add the device, connect zigbee2mqtt.
Check missing controls on device page
Go to bind section, select any endpoint 1->3, left->right and select any device, binding is not possible.

Zigbee2MQTT version

1.35.2 commit: 06b3395

Adapter firmware version

20230507

Adapter

zStack3x0 (development board)

Setup

Container standalone amd64

Debug log

No response

mauritsivs commented 5 months ago

Same here, I have many of these MOES devices, with two and three buttons. The three button version used to be identified correctly. But now is identified as tuya "no neutral" ts0013, while it is a MOES with neutral wire. I am no longer able to change the led back light mode as before. No decoupling possible anymore No binding possible. Somewhere between December and today, something has changed. My entire HA z2m setup was turned off for months because of renovations of my house. I can't find it either in "supported devices" list anymore... What happened?

grabbou commented 1 month ago

I have problem with the 3gang specifically identifying as Tuya and not working properly. I'll try to figure this out and post an update

Koenkk / zigbee2mqtt