Closed corgan2222 closed 3 weeks ago
i have same sensor works without any problems, have you tried to change the battery?
Yes, multiple time. As I wrote, I have 3 of these sensors. 2 of them run completely fine.
I think it's a problem with a specific sensor
I have two of them and haven't seen any problems with spamming
Really strange. After removing the battery for hours, disconnecting the sensor from the mesh and reconnect to the coordinator, it looks good now.
This issue is stale because it has been open 180 days with no activity. Remove stale label or comment or this will be closed in 30 days
What happened?
Hello,
since a while, I notice an insane update rate from one of my Aqara WSDCGQ11LM. I get several hundred updates in a row. Sometimes 3-5 per second. The values itself don't change that much. I already reduced the xx_precision settings to 1. Only 1 of 3 sensors shows this behavior.
The only thing what I could spot was the "power_outage_count" which jump at the end of one of these "outbreaks".
But I could not find "power_outage_count" in the documentation ?
"battery": 97, "linkquality": 69,
What did you expect to happen?
reduce the update rate.
How to reproduce it (minimal and precise)
no idea
Zigbee2MQTT version
1.36.0
Adapter firmware version
20230507
Adapter
Sonoff_Zigbee_3.0_USB_Dongle
Setup
Add-on on Home Assistant 2024.3.1, Raspi5 Supervisor
Debug log