Koenkk
commented
7 months ago @InovelliUSA could you check this?
Closed grraab2000 closed 7 months ago
Koenkk
commented
7 months ago @InovelliUSA could you check this?
InovelliUSA
commented
7 months ago This is fixed in the dev branch:
https://github.com/Koenkk/zigbee-herdsman-converters/pull/7164
@grraab2000 please upgrade to the edge version until the fix gets into production.
Please refer to yellow warning in our help document: https://help.inovelli.com/en/articles/9048636-blue-series-fan-light-module-setup-instructions-zigbee2mqtt
What happened?
Moving from Hubitat (C-8 has physical hardware issues; global variables change values with only 1 set on the system; also way too constricted ), and just getting started with ZigBee (house is mostly Z-Wave, but ....).
So, Installing Inovelli's, VZM36/VZM31-SN under ZHA, but many issues so moving from ZHA to Z2M since I have less than 6 devices. Overall nice. HOWEVER, VZM36 started decently under it and then suddenly changed behavior. Most of the entities just stopped working with this Error: Exception while calling fromZigbee converter: Cannot read properties of undefined (reading 'displayType')}
This is only on the VZM36 Canopy. On exposes, with individual refresh: Light state and brightness work, Followed by Fan state. Sometimes, mode will work, but generally not. Breeze does not have a refresh. And all of the rest throws exception.
The 31-SN works perfectly.
What did you expect to happen?
No response
How to reproduce it (minimal and precise)
The wiring goes through the 31-SN switch, but is set on smart bulb mode (want power and ability to air-drop connection)
Install and pair a Inovelli's VZM36.
Zigbee2MQTT version
Adapter firmware version
6.10.3.0 build 297
Adapter
EZSP v8 from HASS yellow with POE.
Setup
installed to HASS yellow.
Debug log
No response