mrbean27123
commented
2 weeks ago Same thing, and at that sensitivity the sensor started triggering on its own all the time
Open RyeongHoKim opened 3 weeks ago
mrbean27123
commented
2 weeks ago Same thing, and at that sensitivity the sensor started triggering on its own all the time
What happened?
TS0601 _TZE204_7gclukjs
Move sensitivity Presence sensitivity Setting Error
What did you expect to happen?
The presence sensitivity and the move sensitivity value may be set to a minimum of 1 and a maximum of 10. The value should be set when set in the Exposes of the product.
How to reproduce it (minimal and precise)
The value should be set when set in the Exposes of the product. If you set the value to 10 and check it in the state window, it is normally set to 10. However, after a while, the setting value changes to 1. After a little more time, it changes to 0.1 It will eventually change to zero.
Zigbee2MQTT version
1.40.1-1
Adapter firmware version
20221226
Adapter
zStack3x0
Setup
Intel N100 HAOS Addon
Debug log
No response