dav2712
commented
4 days ago After lot of tries, I finally connect theses bulbs. I had to sync the bulb just near by the Zigbee coordinator. The pairing was not working through out a router between the bulb and the coordinator used to increase signal of the network.
What happened?
I recently bought Zigbee LIDL bulbs, model HG08131C. 3 bulbs from a "Home Start Kit" pack, which also included, a Gateway, and a remote control. These bulbs are version 09/2021. I also bought this same bulb, sold as single, which is version 10/2021.
I had no difficulty to pair and use the version 10/2021 bulb, which was correctly recognized by Z2M, and therefore HA.
The 3 bulbs sold in the pack, which are version 09/2021, are not recognized by Z2M at all. To ensure they were working correctly, I used the LIDL gateway, which recognized them (but I do not want to used this gateway). When analyzing the Z2M logs, when the bulbs entered in pairing mode, there are no messages being transmitted at all. I tested individually each bulb. Seems like this devise is totally ignored. Is it possible?
What did you expect to happen?
I expected that the version 09/2021 works as well as the version 10/2021.
How to reproduce it (minimal and precise)
Entered HG08131C version 09/2021 in pair mode, but can not be identified by Z2M
Zigbee2MQTT version
1.40
Adapter firmware version
20240716
Adapter
SLZB-06P7 (TCP/IP)
Setup
Z2M run in Docker on Synology DSM 6.2.4
Debug log
No response