search

Kragrathea / OctoPrint-PrettyGCode

114 stars 20 forks source link

Nozzle - Incorrect height #121

Closed testbughub closed 3 years ago

testbughub commented 3 years ago

Hi!

I just installed the plugin and started a print, when I noticed that the nozzle is going around at the wrong height:
nozzle

I looked around all the issues, but I couldn't find anything on this problem, altough I found #100,
but I'm not sure if it's related (I have Arc Welder installed as well).

If I just missed some information, I apologize.

Kragrathea commented 3 years ago

When you first refresh a page it can take a minute or so to update the nozzle to the correct height. This is due to the way the octoprint sends gcode to the printer. I can only tell the Z height when the layer changes. If you wait does the nozzle eventual start using the correct height?

testbughub commented 3 years ago

Yep, you were right. I gave it a couple of minutes and it started working fine. Thanks for the quick reply, and the plugin, of course!