When plotting a Galvoscan with the limits -1:1 in x and y, only the limits -1:0 appeared on the x axis (though the full plot was shown, only the axes were wrong). The computer had a resolution of 1366x768. Switching the resolution to 800x600 then back caused graph to be displayed properly, but when calling Galvoscan again the new plot was once again wrong. Included in pylabcontrol rather than b26_toolkit because this is likely a global issue with plots.
When plotting a Galvoscan with the limits -1:1 in x and y, only the limits -1:0 appeared on the x axis (though the full plot was shown, only the axes were wrong). The computer had a resolution of 1366x768. Switching the resolution to 800x600 then back caused graph to be displayed properly, but when calling Galvoscan again the new plot was once again wrong. Included in pylabcontrol rather than b26_toolkit because this is likely a global issue with plots.