CC1101 does not receive or transmit anything

LSatan / SmartRC-CC1101-Driver-Lib

This driver library can be used for many libraries that use a simple RF ASK module, with the advantages of the cc1101 module. It offers many direct setting options as in SmartRF Studio and calculates settings such as MHz directly.

Other

432 stars 95 forks source link

CC1101 does not receive or transmit anything #86

Open VIKVIXX opened 3 years ago

VIKVIXX commented 3 years ago

I bought TI-CC1101 and used it with arduino uno to sniff but when i uploaded any code from SmartRC library only thing i get on serial monitor is "Connection OK" i tried already like 6 RF remotes with 433.92 MHz but nothing happened so i bought same but new CC1101 module i also bought arduino mega and logical converter and after was everything was connected and i upload code it said "connection error" but without converter it said again "Connection OK" but still doesnt recieve or transmit anything. what should i do?

0x5c4r3 commented 3 years ago

So, in my experience, I am using an ESP32 with a CC1101. I am able to transmit without problems, but when I try to receive a signal sent from a cheap Radio doorbell transmitting at 433.92 MHz, nothing is detected. Don't know if it's a protocol problem or anything else.

VIKVIXX commented 3 years ago

I tried using my garage door remote Other garage remote house alarm remote And relay RF remote but not a single one was captured

zillawilli commented 2 years ago

Hello I have the same configuration as you (Nano and CC1101) and the same problem. It was not able to read the line "Tx Mode" in the serial monitor. Best regards

frspp commented 1 year ago

Same here - does not receive anything.

Nodemcu ESP32 (ESP32-D0WDQ6) https://www.berrybase.de/esp32-nodemcu-development-board TI CC1101 https://www.makershop.de/module/funk/cc1101-433mhz/

esrsound commented 7 months ago

Same here, esp32 s3.