Laser power weak running job, but tests fine.

[TijuanaKez]

So when I add a test job line cut at %100 power, it doesn't burn and the laser just even looks dim. But in the same workspace, if I set laser test to %100, 100ms, it burns a dot instantly and looks very bright.

This only started happening. On my first test at line cut a circle %100, 800m/m cut rate, it burned fine.

[cprezzi]

It seems you have set your feed units to mm/s (not mm/min), and 800mm/s is probably too height to get burn marks (if your machine can even travel so fast. Try it with 50mm/s or switch default to mm/min.