Open padarom opened 2 weeks ago
pls show a screenshot of Home and Config.
What I just realized when comparing this controller with the working one: The working one uses the STM32 firmware version 1.4.0_Dev_C2 build 21.08.2024
. I'm quite sure the faulty one would've had the same version, but I wanted to see if a firmware re-flash would fix the issue and the newest one I could find in the repo was 1.3.7.
Here's the screenshots you asked for:
The config looks fine. The latest firmware is on my github : https://github.com/SurfGargano/VdMot_Controller/releases/latest
Do you have tried to change the WTH and the STM from the not working one into the working one and vice versa ?
I recently ordered and assembled two kits which I intended to use with 11 valves each. The first kit went smoothly, the second one showed me some strange behavior when trying to install and set up all the valves.
Took me a while to isolate the issue, but it turns out that:
For now I am running it with X3 and X4 disconnected, but I'm wondering about what caused this. Is it somehow obvious if this is a PCB/BluePill/... issue, or does this not make sense for anyone else either? I rechecked all my solder spots to see if I inadvertently connected two pins but they all look fine to me. I also resoldered the connectors for X3 and X4 but the issue persisted.
Thanks for any help or hints!