The LinuxCNC issue tracker is to report bugs in the software.
If you have a question about how to use the software, use one of the other methods detailed on our community support page: http://linuxcnc.org/community/
(delete this section before submitting your bug report)
Here are the steps I follow to reproduce the issue:
1.
2.
3.
This is what I expected to happen:
This is what happened instead:
It worked properly before this:
(If the behavior changed after making a particular change in hardware or
software, describe the change you think is responsible. E.g., "after upgrading
from LinuxCNC 2.7.3 to 2.7.4")
Information about my hardware and software:
I am using this Linux distribution and version (often, shown by lsb_release -a):
I am using this kernel version (shown by uname -a):
I am running ...
[ ] A binary version from linuxcnc.org (including buildbot.linuxcnc.org)
[ ] A binary I built myself
[ ] A binary version from some other source besides linuxcnc.org
I am using this LinuxCNC version (shown in package manager or, for git versions, scripts/get-version-from-git):
I am using this user interface (GUI) (e.g., AXIS, Touchy, gmoccapy, etc):
I am using this interface hardware vendor and chipset (e.g., parallel port, ethernet port, FPGA card):
The issue tracker is not a support forum
The LinuxCNC issue tracker is to report bugs in the software. If you have a question about how to use the software, use one of the other methods detailed on our community support page: http://linuxcnc.org/community/
(delete this section before submitting your bug report)
Here are the steps I follow to reproduce the issue:
1. 2. 3.
This is what I expected to happen:
This is what happened instead:
It worked properly before this:
(If the behavior changed after making a particular change in hardware or software, describe the change you think is responsible. E.g., "after upgrading from LinuxCNC 2.7.3 to 2.7.4")
Information about my hardware and software:
lsb_release -a
):uname -a
):scripts/get-version-from-git
):