search

Lite3DP / Lite3DP-Gen-2

MSLA 3D printer, ESP32 based, Arduino compatible
https://www.lite3dp.com/
Other
44 stars 6 forks source link

platform got stuck moving up #4

Closed chri2 closed 4 weeks ago

chri2 commented 1 month ago

when doing the test print of the keychain with the default parameters at some point the platform didn't move up further than some point and the printer made some mechanical noise. This repeated driving the platform up and down and when the print finished I had to carefully help the platform going up.

The print ended without the Lite imprint on the keychain - obviously because the platform didn't loosen from the release film.

I tried again with slightly adjusted parameters:

Bottom lift height: 8.00 mm Lift height: 6.00 mm Lift speed: 1.30 mm/s

With those changes it worked.

andypiper commented 1 month ago

what / where are the keychain and touchpen test prints you refer to in this issue and other issues?

^^ ignore, I realise these are the test prints in the firmware now.

Lite3DP commented 4 weeks ago

Ensure proper platform adjustment and adequate lifting speed.