Great work on these cases! I really like your design.
I've printed two of them out of PETG with a brim, and both times the edge next to the largest hole lifted at the bottom even though there was a brim. It actually pulled away from the brim, which stayed on the build plate. I did one print without part cooling, and on with it on at 100% and the results were the same. I know Fusion 360 and will see if I can find a mod that might fix the problem. My settings were 0.2mm layer height, 20% infill, print cooling on once and off once, no support, with a build plate at 60 o C and print temp at 230 o C. I leveled the bed with a BL Touch before printing.
Great work on these cases! I really like your design. I've printed two of them out of PETG with a brim, and both times the edge next to the largest hole lifted at the bottom even though there was a brim. It actually pulled away from the brim, which stayed on the build plate. I did one print without part cooling, and on with it on at 100% and the results were the same. I know Fusion 360 and will see if I can find a mod that might fix the problem. My settings were 0.2mm layer height, 20% infill, print cooling on once and off once, no support, with a build plate at 60 o C and print temp at 230 o C. I leveled the bed with a BL Touch before printing.