alarm from bms in Venus OS that are not showing blue tooth and phone

[MS123uk]

Have installed the driver for bms comm in Raspberry Pi 4b running Venus OS 2.91 the from off grid garage video and your all work ok to start with until a lot alarms started showing in alarm log on portal but not showing on the phone app ? e.g. low temp charge - over current charge and so on you can clear them by rebooting Raspberry from the soft ware. having unplug the comm lead and reset the solar controller to default to stop (bms comm 67 alarm ) at the solar controller program will run ok until with out the bms comm being plug in all starts again to day alarms for the bms but its not plug in

**VenusOS 2.91

• Device type: [ Raspberry Pi 4b ]
• Firmware Version [e.g. 262]

Battery/BMS (please complete the following information):

• BMS/Battery type: JBD - liftpo4
• Cells: [e.g. 16] 8
• Interface: [e.g. USB- to UART

Additional context Add any other context about the problem here.

[Louisvdw]

Can you please upload the log file for the serialbattery on your bms port after you see this problem. https://github.com/Louisvdw/dbus-serialbattery/wiki/Troubleshoot

[MS123uk]

Thank for prompt reply i had !!!! last night i have remove diy usb to rs232 leads and using the only Victron usb to VE direct and the bms to usb uart plug in and so far . if the problem show again i will upload the logs i have order isolated 4 way usb port and Ve direct leads as show on off grid garage video link finger cross

[Louisvdw]

OK. I'll close the issue for now. You can come here and reopen it again if you need too

[MS123uk]

Diy usb to uart leads are not worth cash saved only go Victron usb to VE direct or isolated 4 way usb port and Ve direct leads as show on off grid garage wills save you hole load grief

[MS123uk]

isolated 4 way usb port and Ve direct leads as show on off grid garage try this to day and same problem shown high battery temp- low temp - and so on driver for bms that`s not plug in shown device list