search

Lzhikai / SIBOOR-Voron-0.2

45 stars 5 forks source link

unsafe default settings #18

Closed shiftingtech closed 1 month ago

shiftingtech commented 1 month ago

It is dramatically dangerous to set min_temp:-100 on the extruder and bed, as seen in your printer.cfg

This setting effectively disables the first line of defense against wire breaks or thermistor failures

Lzhikai commented 1 month ago

This is the lowest temperature, not the highest temperature, so the danger is not as high as you think. You can make a modification, and I will update later

shiftingtech commented 1 month ago

This is not correct information: a wire break causes a negative reading.

On Mon, Jul 15, 2024, 9:15 p.m. slippers @.***> wrote:

This is the lowest temperature, not the highest, so the danger isn't as high as you might think, and you can make one modification since the kit is no longer for sale, so maybe no more changes will be made.

— Reply to this email directly, view it on GitHub https://github.com/Lzhikai/SIBOOR-Voron-0.2/issues/18#issuecomment-2229922203, or unsubscribe https://github.com/notifications/unsubscribe-auth/AMVRUAP4AKW6NPFN6XLGW5LZMSF63AVCNFSM6AAAAABK5VUONKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDEMRZHEZDEMRQGM . You are receiving this because you authored the thread.Message ID: @.***>

Lzhikai commented 1 month ago

I'm modifying it now, thanks for the heads up

Lzhikai commented 1 month ago

Changed it to -10, so I'm about to close the place.