search

Lzhikai / SIBOOR-Voron-0.2

45 stars 5 forks source link

Motor voltages on X/Y are too high. reduce them to prevent overheat failures #6

Closed greenaar closed 1 year ago

greenaar commented 1 year ago

X/Y should not be at 1.1

This will cause the motors to heat unnecessarily, and risk failures on long prints. Setting them to 0.8 still provides enough torque to print without issues, while removing one likely failure point.

asychev commented 1 year ago

current printer.cfg has it overwritten and set to 1.1 again

Lzhikai commented 1 year ago

current printer.cfg has it overwritten and set to 1.1 again

Is there any irregularity in keeping the running current at 0.8? We're just trying to be conservative.

asychev commented 1 year ago

@Lzhikai But it is not 0.8, but 1.1 again, see https://github.com/Lzhikai/SIBOOR-Voron-0.2/blob/main/printer.cfg#L162