While Probe Holder v1 fits the magnet, some little things could be improved:
[ ] Slightly reduce width. The width seems to change throughout the magnet and the fit is already very tight. A slightly reduced width maybe by the tolerance of the printer would give it a bit easier slide in (width -= ~0.2mm)
[ ] Same for the height
[ ] The holder currently is of the same length as the white magnet standoffs ( 88.35mm ). This could be extended until the end of the PCB to be completely flush.
[ ] A stopper that prevents the holder from completely sliding through could help positioning the probe at the same place reproducibly.
[ ] A handle to pull the holder out again on the side of the stopper would make handling easier
[ ] Round off/chamfer insertion side for easier (and straight) entry into the magnet
While Probe Holder v1 fits the magnet, some little things could be improved: