search

MKFirmware / MK4duo

MK4duo Firmware Printers 3D for Arduino and Arduino due
http://www.marlinkimbra.it
GNU General Public License v3.0
206 stars 117 forks source link

Extruder manual moving (from LCD) bug #648

Open Hans007a opened 5 years ago

Hans007a commented 5 years ago

Hello,

I found a bug in the last release. Anything is wrong with the manual move the extruders from the LCD display. When I go to the move menu and select one of the three extruders many times the menu switch back to the info display and don't show the move length selection. Many times I ca go to the selection of the move length but after select one of them the system is going to the info display.

My printer is a CoreXY with one nozzle and 3 extruders.
Board: BOARD_RAMPS_FD_V1 with I2C EEPROM, REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER and ESP8266 on serial3

Regards

Hans

MagoKimbra commented 5 years ago

Ok i check this!!!

Hans007a commented 5 years ago

Sorry, I put the wrong printer data, here are the right data:

Printer is a Cartesian with one nozzle and 3 extruders. Board: BOARD_RAMPS_FD_V1 with I2C EEPROM and REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER

Thank You, that You will show this bug :)

Regards

Hans

Hans007a commented 5 years ago

any news? I flashed today the new release and the bug is still there...