search

MKFirmware / MK4duo

MK4duo Firmware Printers 3D for Arduino and Arduino due
http://www.marlinkimbra.it
GNU General Public License v3.0
206 stars 117 forks source link

Homing on Deltaprinter after restoring Factory defaults doesn,t stop on Endstops #680

Closed hagre closed 5 years ago

hagre commented 5 years ago

Issue description

Every time after restoring factory settings with the LCD Menue or M502 (and saving to EEPROM - M500) the homing on my Delta is broken. It is moving up in direction Zmax but do not stop when hiting the endstops. After switching off power and boot again everythimg is working as it should. My workaround is to reeboot after restoring the factory defaults to avoid crash on first homing.

M119 and endstops are working correct. To enable endstop with M120 made no change to the problem.

Firmware version

MK4duo - Firmware configurator tool (Rev 4.3.5) - Firmware Version 4.3.8 (Rev 20022019) with some changes

My setup

Anycubic Kossel Linear Plus Configuration_Overall.txt

MagoKimbra commented 5 years ago

When you reset eeprom with M502 and M500 all pins are reinitialize, this procedure not like to processor. Now when you put M502 and M500 reset the printer switch off and switch on).