Delta does no Bed Leveling

MKFirmware / MK4duo

MK4duo Firmware Printers 3D for Arduino and Arduino due

http://www.marlinkimbra.it

GNU General Public License v3.0

206 stars 117 forks source link

Delta does no Bed Leveling #684

Open Andy-27 opened 5 years ago

Andy-27 commented 5 years ago

Issue description

When running G29 the printer is homing and after that going into position as set in configuration_delta.h in Z_PROBE_DEPLOY_HEIGHT and then stops. No further move is made, even if coordinates are set for a probe according Allen Key.

Firmware version

MK4duo's versions 4.3.8

My setup

Configuration_Delta.h.txt Configuration_Feature.h.txt

Would appreciate any comments on getting this issue sorted out.

Grazie Mille

Andy-27 commented 5 years ago

I use a probe similar to Allen Key, it is deployed by moving in +Y direction and stowed by moving in -Z direction.

Andy-27 commented 5 years ago

There is no difference between enabled or disabled "#define PAUSE_BEFORE_DEPLOY_STOW"