search

MNieddu91 / Marlin-AI3M-BLTouch

Marlin firmware optimized for the Anycubic i3 Mega 3D printer
GNU General Public License v3.0
94 stars 28 forks source link

Unable to export compiled binary through Arduino 1.8.9! #10

Closed jeffgram closed 5 years ago

jeffgram commented 5 years ago

Hello My professional dear, I am having Anycubic Mega S. I am currently having a new issue to export the compiled binary as hex through Arduino 1.8.9 software, which I never had this issue before. But now I have encountered this unexpected error of red highlight at the bottom saying "Sketch uses 125320 bytes (49%) of program storage space. Maximum is 253952 bytes. Global variables use 6638 bytes (81%) of dynamic memory, leaving 1554 bytes for local variables. Maximum is 8192 bytes. Low memory available, stability problems may occur." Could anyone of you help me out? I would owe you my appreciation and support. My email: sawak.the.great@gmail.com Best regards, Jeff.

MNieddu91 commented 5 years ago

1554bytes is more than enough. Just ignore this warning and flash the hex. Marlin need around 1000bytes to run properly.

jeffgram commented 5 years ago

Hello, Thanks for your reply. I do really appreciate. Could you please help me out.I have unexpected issue since yesterday and I didn't sleep at all until morning. I have AnyCubic i3 Mega upgraded to Mega S. Yesterday, after i flashed Marlin 1.1.9 on my 3D printer. I printed many files and it was printing without filament out of the nozzle. I checked the extruder, which was still rotating.Then, i realized that slicer had an issue of its configuration profile. I checked it was all ok as I used to print through. Finally, i thought its extruder had an issue. Therefore, i replaced it with my old extruder Mega i3 and flashed it, yet result showed the same. I did all i could until I went so disappointed and frustrated. If you could help me to solve my issue, i would make a donation for you. This is my week old 3d printer.

Best regards, Jeff

On Tue, Apr 16, 2019, 10:10 AM sawak sawak sawak.the.great@gmail.com wrote:

Hello, Thanks for your reply. I do really appreciate. Could you please help me out.I have unexpected issue since yesterday and I didn't sleep at all until morning. I have AnyCubic i3 Mega upgraded to Mega S. Yesterday, after i flashed Marlin 1.1.9 on my 3D printer. I printed many files and it was printing without filament out of the nozzle. I checked the extruder, which was still rotating.Then, i realized that slicer had an issue of its configuration profile. I checked it was all ok as I used to print through. Finally, i thought its extruder had an issue. Therefore, i replaced it with my old extruder Mega i3 and flashed it, yet result showed the same. I did all i could until I went so disappointed and frustrated. If you could help me to solve my issue, i would make a donation for you. This is my week old 3d printer.

Best regards, Jeff

On Tue, Apr 16, 2019, 5:08 AM Marco Nieddu notifications@github.com wrote:

1554bytes is more than enough. Just ignore this warning and flash the hex. Marlin need around 1000bytes to run properly.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/MNieddu91/Marlin-AI3M-BLTouch/issues/10#issuecomment-483399169, or mute the thread https://github.com/notifications/unsubscribe-auth/AvNQfteeljdyPb9-WbPXzLUzwDIGQm1lks5vhNwpgaJpZM4cuHM8 .