TriVibe Calibration with Dytran

[MachineSaver]

• [x] ComCalibrator Application is Ready to Test -per Oguz
• [x] Need to setup remote access to a computer hooked up to the shaker/circuit.
• [x] Changing Dytran RTU to 254 - so it will never conflict with Production TriVibes

[MachineSaver]

To Speed Up and Remove Human Error (Oguz Original Goal)

• [x] Ready for Igor to connect and update the ComCalibrator software.
• [x] @MachineSaver to setup a 2nd bus/COM Port for Test.
• [ ] @MachineSaver Read from Dytran and Save to TriVibe Digital. Unable to do this with program, it does not complete read between TriVibe and Dytran, Igor is investigating
• [ ] @MachineSaver Change frequencies and see what those Milivolt values are for different frequencies.

If we want to use a single bus (less COM ports with less complicated software) with 2 sensors (Dytran and Sensor Being Calibrated)

• [ ] Design a 3 Channel Dytran Circuit

To Flatten the Frequency Response (A Separate Goal)

• [ ] Vitaliy will need to Design the Firmware - Use Different Measurement Points to Calculate at different frequencies.
• [ ] Igor would need to write the software to control the RedPitaya sweep.

[MachineSaver]

Igor identified an issue with the new com calibrator software that is running very slowly when making the request switching between the TriVibe Digital board connected to the dytran and the TriVibe under calibration.