search

Macrobase-tech / MKS-DLC32

MKS DLC32 is 32bit MCU powerful controller for CNC machine.
https://www.aliexpress.com/item/4000828878233.html?spm=a2g0o.store_pc_topSellerIng.8148356.7.6ab922a9BYVuPh
42 stars 21 forks source link

The X and Y axes are rotated by 45 degrees #10

Open SergChel opened 2 years ago

SergChel commented 2 years ago

With "MKS DLC32+TS24" firmware for the laser, the X and Y axes are rotated by 45 degrees. Instead of moving in a straight line, the laser goes diagonally. Instead of moving diagonally, the laser goes straight. If I download the firmware for the CNC, the bug disappears. I have problem with the V2.08_H24_20211223_C.bin and V2.08_H24_20220107_C.bin firmware from this site.

Macrobase-tech commented 2 years ago

Hello,please try below firmware. https://github.com/Macrobase-tech/MKS-DLC32/tree/main/MKS%20DLC32%2BTS24/Firmware/CNC

------------------ 原始邮件 ------------------ 发件人: "Macrobase-tech/MKS-DLC32" @.>; 发送时间: 2022年7月16日(星期六) 晚上7:31 @.>; @.***>; 主题: [Macrobase-tech/MKS-DLC32] The X and Y axes are rotated by 45 degrees (Issue #10)

With "MKS DLC32+TS24" firmware for the laser, the X and Y axes are rotated by 45 degrees. Instead of moving in a straight line, the laser goes diagonally. Instead of moving diagonally, the laser goes straight. If I download the firmware for the CNC, the bug disappears. I have problem with the V2.08_H24_20211223_C.bin and V2.08_H24_20220107_C.bin firmware for from this site.

— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.Message ID: @.***>

SergChel commented 2 years ago

Hello,please try below firmware. https://github.com/Macrobase-tech/MKS-DLC32/tree/main/MKS%20DLC32%2BTS24/Firmware/CNC …

When I use this firmware laser does not works in the dinamic mode, it works only in the constant power mode.

Macrobase-tech commented 2 years ago

My colleague had sent another fw to fit your machine.

------------------ 原始邮件 ------------------ 发件人: "Macrobase-tech/MKS-DLC32" @.>; 发送时间: 2022年7月19日(星期二) 凌晨2:27 @.>; @.**@.>; 主题: Re: [Macrobase-tech/MKS-DLC32] The X and Y axes are rotated by 45 degrees (Issue #10)

Hello,please try below firmware. https://github.com/Macrobase-tech/MKS-DLC32/tree/main/MKS%20DLC32%2BTS24/Firmware/CNC …

When I use this firmware laser does not works in the dinamic mode, it works only in the constant power mode.

— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you commented.Message ID: @.***>