Out of the initial 6 tips that I printed only 1 allowed full movement of the dowel to allow the switch to click. I suspect the measurements are correct but the tolerance is very low, so to make this have a slightly wider margin of error we can just cut 1mm from this model. I tried messing with the limiter a bit, but ultimately found it much easier to simply cut the bottom millimeter off the tip in prusaslicer. To preserve the aesthetic we should just take 1mm from the middle of the model.
I'm happy to do this when I get around to it, mostly just wanted to create this issue to track since multiple people in the discord have mentioned having issues with this part.
Out of the initial 6 tips that I printed only 1 allowed full movement of the dowel to allow the switch to click. I suspect the measurements are correct but the tolerance is very low, so to make this have a slightly wider margin of error we can just cut 1mm from this model. I tried messing with the limiter a bit, but ultimately found it much easier to simply cut the bottom millimeter off the tip in prusaslicer. To preserve the aesthetic we should just take 1mm from the middle of the model.
I'm happy to do this when I get around to it, mostly just wanted to create this issue to track since multiple people in the discord have mentioned having issues with this part.