lalo-uy
commented
4 years ago ChecK this command: sqlite3 craftbeerpi.db "select * from config where name='buzzer'" mine say: buzzer|16|select|Buzzer GPIO|[0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,26,27]
if not you can modify craftbeerpi.db with sqlite3
El lun., 15 jun. 2020 a las 15:37, lazarosatiro (notifications@github.com) escribió:
Hello,
Use an interface board to control my process (TERRAGADY V5.0), as my beep is soldered at gpio 25. When you can access parameters> the beep, you can select as gpios 16 to 23.
What makes me more intrigued is the update script (which releases folders, but is not working.
I'm using a raspberry pi4.
I have already installed the software and updated several times without success.
Anyone who can help me will be grateful.
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/Manuel83/craftbeerpi3/issues/255, or unsubscribe https://github.com/notifications/unsubscribe-auth/ACXBW4IJK7YPKISPGDLRTVLRWZS7LANCNFSM4N6N2FQQ .
Hello,
I use an interface board to control my process (TERRAGADY V5.0), my beep is soldered at gpio 25. When i access parameters> the beep, i can't select gpio 25 because i see only gpios 16 to 23.
What makes me more intrigued is the update script stay the folder "update" but is not working.
I'm using a raspberry pi4.
I have already installed the software and updated several times without success.