search

Maritime-Robotics-Student-Society / Boat-construction

4 stars 4 forks source link

Design ring to increase rudder rod diameter #23

Open smaria opened 8 years ago

smaria commented 8 years ago

since the rudder rod is fairly loose in the shaft, it needs some 3d printed part around it, that goes in at the top of the shaft

smaria commented 8 years ago

What are the tolerances of the measurements? E.g. is the 4mm diameter the diameter of the current rod, and needs adding of a tolerance for allowing rotation?

Nanoseb commented 8 years ago

The measurements in the draft are the actual one, no tolerances have been added. So you are right, this value will have to be slightly higher to be able to rotate properly.

smaria commented 8 years ago

This was made with the correct tolerances by my brothers, will arrive Friday (will close when it is here)