Closed vef445 closed 7 years ago
Update: The same person actually succeed treating this file (he was a victim of the cylinder bug). Still I can't deal with his file, I think it's worth looking at it.
In what way can you not deal with it? Mark
I can't see anything strange with the GCODE?
Sorry I didn’t get back to you on that one… please leave it open, I’ll look at it again tomorrow.
By the way, I received the following bug report about some sort of “welding” mark in cylinder mode, I’ll open a new issue on Github tomorrow.
On 11 Apr 2017, at 23:41, Mark Wheadon notifications@github.com wrote:
I can't see anything strange with the GCODE?
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/MarkWheadon/velocity-painting/issues/20#issuecomment-293408977, or mute the thread https://github.com/notifications/unsubscribe-auth/AFoIiqK8cRaPsoaQK2eAPyzw0boVE4nhks5ru_OTgaJpZM4M4E8z.
Right you are.
Mark
On Tue, 11 Apr 2017, 22:43 vef445, notifications@github.com wrote:
Sorry I didn’t get back to you on that one… please leave it open, I’ll look at it again tomorrow.
By the way, I received the following bug report about some sort of “welding” mark in cylinder mode, I’ll open a new issue on Github tomorrow.
On 11 Apr 2017, at 23:41, Mark Wheadon notifications@github.com wrote:
I can't see anything strange with the GCODE?
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub < https://github.com/MarkWheadon/velocity-painting/issues/20#issuecomment-293408977>, or mute the thread < https://github.com/notifications/unsubscribe-auth/AFoIiqK8cRaPsoaQK2eAPyzw0boVE4nhks5ru_OTgaJpZM4M4E8z .
— You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub https://github.com/MarkWheadon/velocity-painting/issues/20#issuecomment-293409362, or mute the thread https://github.com/notifications/unsubscribe-auth/AYZjUcPvk83nUjB4zphKy3otbUcXkKRlks5ru_P5gaJpZM4M4E8z .
Issue was on my side, you can close @MarkWheadon
Hi @MarkWheadon , Someone sent me his gcode and it seems impossible to digest it, see attached file. The slicer is Cura, delta printer (Kossel plus), Marlin firmware. jarron spiral grande.gcode.txt