Problem with communication

MarlinFirmware / Marlin

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.

https://marlinfw.org

GNU General Public License v3.0

16.17k stars 19.21k forks source link

Problem with communication #2828

Closed SDmodelar closed 8 years ago

SDmodelar commented 8 years ago

Hello everyone, I am a beginner in making 3D printers and I used Ramps 1.4 Marlin Firmware 1.0.2.
I have a problem communicating with sw Pronterface and Repetier. When I use the Arduino sw communication works.

Best regards

KiteLab commented 8 years ago

Pick the right serial port with the baud rate in your Configuration.h and it will work.

thinkyhead commented 8 years ago

I will assume this problem is solved by now. :+1:

github-actions[bot] commented 2 years ago

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.