Closed belial1 closed 2 years ago
Ambient temp. around 14 deg С. ABS+ plastic need abt 15 min to heat up bed to 115.
Put your printer in an enclosure. You will continue to have issues trying to heat a bed that size, to those temperatures, in a room that cold.
This Issue Queue is for Marlin bug reports and development-related issues, and we prefer not to handle user-support questions here. (As noted on this page.) For best results getting help with configuration and troubleshooting, please use the following resources:
After seeking help from the community, if the consensus points to a bug in Marlin, then you should post a bug report.
Have problem with timing for bed temperature . CR10V3 printer, Marlin 2.0.9.3. Ambient temp. around 14 deg С. ABS+ plastic need abt 15 min to heat up bed to 115. So after 10 min bed warming always receive error " bed temp, reset printer" message. And printer freeze. Is it possible to adjust timeout for bed temp. settings independant of plastic type and add it for settings?