Closed inspectionsbybob closed 2 years ago
Was meaning to edit that block in config_adv shortly anyway to better call out the sequence to enter mirror mode as a few were struggling with it. Ill Rectify it later today.
Edit : I should note this is more an issue with the docs repo out of sync with the comments in the actual config file. Config file is fine, aside from what i planned to add later anyway.
Documentation updated, thanks!
Did you test the latest
bugfix-2.0.x
code?Yes, and the problem still exists.
Bug Description
MINOR Typo in the Marlin documentation
In Configuration_Adv.H
Mode 0: Full Control Mode. (M605 S1) Slicers that fully support dual X-carriages can use this mode for optimal travel results. Mode 1: Auto-park Mode. (M605 S1) The firmware automatically parks/unparks the carriages on tool-change. No slicer support is required. (M605 S1)
It calls out S1 for BOTH Full Control and AutoPark and other modes as well. Looks like a Cut-n-paste error.
The Documentation for M605 is correct.
Bug Timeline
Allways
Expected behavior
Typo
Actual behavior
should be S0 and S1
Steps to Reproduce
Open documentation
Version of Marlin Firmware
current online documentation
Printer model
NA
Electronics
NA
Add-ons
NA
Bed Leveling
No response
Your Slicer
No response
Host Software
No response
Additional information & file uploads