search

McDermott-Group / servers

Public repo that stores LabRAD servers and other non-measurement related code
0 stars 2 forks source link

[ADR GUI] Not user-friendly behavior upon reaching maximum magnet current #16

Closed patzinak closed 8 years ago

patzinak commented 8 years ago
  1. One has to manually press "Stop Magging Up" button before magging down even though the current stays above 9A (reads 9.00581 A) for a half an hour.
  2. When target temperature is chosen to be 0 K, the log box shows "Starting regulation to 0.1 K from 9.00581" but the regulation box shows 0 K. This is confusing.
patzinak commented 8 years ago
  1. Regulation is completed when the current is still quite high (a good fraction of an ampere, TmK > 120 mK). Do not display the log message until the current reading is less than let's say 0.01 A or remove phrase "Mag up and try again."
roboguy222 commented 8 years ago

This has been changed from stopping regulation when the voltage is close to 0 to stopping when the current is close to 0.