I was wondering if you could release pin names layout in the board, for both Marlin and RepRap Firmware,
I'm trying to figure out how to configure a PSU Control in RepRap Firmware in the FLY-CDY.
I was also reading the FLY-CDY Use tutorial.pdf and it says to "Plug all the pins around the WiFi Module" but it isn't very clear why and when should they be unplugged, I'll be getting my board tomorrow so I'm excited for the new challenge!!!
FLYmaker
commented
3 years ago
I was wondering if you could release pin names layout in the board, for both Marlin and RepRap Firmware, I'm trying to figure out how to configure a PSU Control in RepRap Firmware in the FLY-CDY.
I was also reading the FLY-CDY Use tutorial.pdf and it says to "Plug all the pins around the WiFi Module" but it isn't very clear why and when should they be unplugged, I'll be getting my board tomorrow so I'm excited for the new challenge!!!
Thank you