search

Mellow-3D / FLYF407ZG

31 stars 12 forks source link

Jumpers under drivers #2

Open apsbiker opened 4 years ago

apsbiker commented 4 years ago

Any way we can get a hookup guide for the board? There are many jumpers available under the driver board area (far more than the normal 3 jumpers for MS1, MS2, MS3) but no documentation as for what jumper controls what setting.

20200108_182918

FLYmaker commented 4 years ago

Default mode

OF}ZNFKK)N0% MS@(6WI9QQ

spi mode QD04~6 I5)W92}${`4C _GJ

uart mode CNQQ75NH`O$9_7GNRAMN ZK

naorbonomo commented 4 years ago

How do you enable sensorless homing? which pins need to be wired where?

Nazrac commented 4 years ago

I can tell you by the board that sensorless homing will not work, unless you make jumpers from the DIAG pin on the driver to the endstop input. You can do any board with sensorless homing if you make the flying leads, but that is what BTT has made easy on their boards. There would be another set of 2 connectors just beside the EN(enable) pin. I am seriously thinking about this but my SKR pro with some ingenuity would be able to support 9 steppers if you get creative with the expansion ports. The worst part of this board is the lack of documentation, along with the lackluster onboard mosfet for the heated bed, but I run mosfets anyways. But realistically you could set this up to run a Ender 5 style cartesian with dual carriages 3 z steppers for auto 3 point leveling and still have room for a dual extruder (chimera/cyclops) on one carriage and a run of the mill V6 or Mosquito on the other. Or a coreXY with a toolchanger setup and 4 extruders still keeping the 3 stepper autoleveling. Thats also assuming you can figure out how to drive the system without all the auxiliary pins.

naorbonomo commented 4 years ago

I am looking for the DIAG pin todo just that, but i dont know which one of the three it is