confusion about cp/m programs on SDX rpi pico

DuckyPolice commented 3 months ago

How am i supposed to run and load cp/m programs in the SDX mode of the rpi pico version of memu (which i have grown to love) such as hextrain? i selected the "games" rom as B and ran "USER DIR" and saw all the games listed. i dont know where to go from here. i have tried "USER LOAD HEXTRAIN.COM" but after a few seconds it returns "No data"

Memotech-Bill commented 3 months ago

They are CP/M programs. You have to start them from CP/M mode. Once started most of them use the VDP display. Use Ctrl+FN_key to switch between the different display modes.

DuckyPolice commented 3 months ago

when i press + (shift equals key) nothing happens is there a difference like how qotes are shift+2?

On Fri, Jun 14, 2024, 2:28 AM Memotech-Bill @.***> wrote:

They are CP/M programs. You have to start them from CP/M mode. Once started most of them use the VDP display. Use + to switch between the different display modes.

— Reply to this email directly, view it on GitHub https://github.com/Memotech-Bill/MEMU/issues/6#issuecomment-2167524079, or unsubscribe https://github.com/notifications/unsubscribe-auth/AS4QRIR2NJYYZDTZ5FL6373ZHKSUNAVCNFSM6AAAAABJJO7AR6VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCNRXGUZDIMBXHE . You are receiving this because you authored the thread.Message ID: @.***>

DuckyPolice commented 3 months ago

nvm i read the docs it was ctrl+f1

Memotech-Bill / MEMU

confusion about cp/m programs on SDX rpi pico #6