search

MichelMoriniaux / BigPowerBox

An open source power distribution switch for 12VDC applications
Other
16 stars 2 forks source link

Zero Vaules for temp sensor in NINA #12

Closed TimSha2509 closed 2 months ago

TimSha2509 commented 3 months ago

I’ve built your powerbox and so far it worked flawlessly (thanks a lot for your amazing work!). However I just now decided to add a temperature probe and so far, Temp and Humidity will only be displayed as „0“ in NINA.

I have verified that the SHT31 sensor I’m using is actually working with the board by checking the device info in the Arduino IDE, where everything works great and the temperature is shown correctly.

I’ve already reinstalled the Ascom driver and also tried an older version to no avail so far. Any ideas what might cause this?

MichelMoriniaux commented 3 months ago

Hello, is the '0' value in the switches section? it should appear there not under weather. I would need to go to my remote observatory ( next scheduled is in 2 weeks ) to do a test and confirm ( I do not have temp probes currently plugged in)

TimSha2509 commented 3 months ago

Hey!

Yes it’s listed as "Env Temp" etc. right where it also appears in your screenshot on the main page. Thanks a lot for your efforts!

rohan5sep commented 2 months ago

While building this box I noted following: It takes over a minute for the values to be populated. Also, the temperature prob must be attached before booting up the power box.

Just sharing in case it helps...

TimSha2509 commented 2 months ago

Omg lol. I used a faulty sensor in my first attempt and after exchanging it during trouble shooting I never bothered to wait for a whole minute. That has done the trick.

I’ll try a setup incl. the multiplexer sometime in the future and come back, should I encounter issues there, but for now this issue has been resolved thanks to your assistance!