Closed stc1988 closed 6 months ago
Hello @stc1988, the target esp32/esp32c6
uses UART for debugging.
Please try to add "USE_USB": "2"
to the build
section of your device manifest.
Like:
"build":{
"ESP32_SUBCLASS": "esp32c6",
"USE_USB": "2"
},
This section in the documentation describes it: https://www.moddable.com/documentation/devices/esp32#using_usb
@mkellner Thank you for confirming.
Please try to add "USE_USB": "2" to the build section of your device manifest.
I got it working this way! I will make PR for esp32/m5nanoc6
later.
Now I'm trying to add new device M5nanoC6 that equipped with an ESP32-C6 in my branch.
release build with
mcconfig -i
shows console log on my terminal and application works fine, so I think flashing firmware is going well. On the other hand, debug build withmcconfig -d
shows no output on xsbug.Below is part of the log.I don't know if it's a device issue or an esp32c6 issue. Is there any way I can investigate?