It set the tempearute on 180 °C for prehead and 200°C on print.
I looked at the diffrence between the original code from Cura an the gcode after the script. Only to 3 Part are diffrent:
My comand is the following:
py wood.py -s 3 -i 180 -a 230 -g 3.0 -w M109 --file ../gcode_Todo/hannah_ring.gcode
Sorry, I'm here very rarely, this super old script is almost frozen now.
Could you post your gcode somewhere so I can give it a try (thanks for the CLI you used) ?
I use Cura 4.7 and the script is not working.
It set the tempearute on 180 °C for prehead and 200°C on print. I looked at the diffrence between the original code from Cura an the gcode after the script. Only to 3 Part are diffrent:
My comand is the following:
py wood.py -s 3 -i 180 -a 230 -g 3.0 -w M109 --file ../gcode_Todo/hannah_ring.gcode