Running Dynamo 2.0.2 with Revit 2018. Attempted to complete in 2019 with same results.
I tried rolling back to earlier versions of Data-Shapes in the package manager before a 2.0.2 Dynamo release, i.e. before December. Still getting similar results. Also, do not know if this is a DS or a Dynamo issue.
This is on a new laptop with R18 and R19 recently installed, along with Dynamo. Before running a DS node, everything runs perfectly. Everything is set to manual mode to run in Dynamo. Click Run. Everything in Dynamo and DS runs as expected. DS shows a UI that it is supposed to show. After completing the action, Dynamo UI become active again and the workspace runs fine, menus, and everything else runs fine. The left hand of the UI where packages and native Dynamo nodes becomes frozen and does not respond. Save the graph, close the application. If attempting to reopen the application, it will crash the Revit application.
Don't know if there is a way to cross-reference an issue between two repos, but maybe this is supposed to go over to Dynamo's repo also.
No other third party packages are installed. Clean Dynamo and only DS installed.
Hey all-
Running Dynamo 2.0.2 with Revit 2018. Attempted to complete in 2019 with same results. I tried rolling back to earlier versions of Data-Shapes in the package manager before a 2.0.2 Dynamo release, i.e. before December. Still getting similar results. Also, do not know if this is a DS or a Dynamo issue.
This is on a new laptop with R18 and R19 recently installed, along with Dynamo. Before running a DS node, everything runs perfectly. Everything is set to manual mode to run in Dynamo. Click Run. Everything in Dynamo and DS runs as expected. DS shows a UI that it is supposed to show. After completing the action, Dynamo UI become active again and the workspace runs fine, menus, and everything else runs fine. The left hand of the UI where packages and native Dynamo nodes becomes frozen and does not respond. Save the graph, close the application. If attempting to reopen the application, it will crash the Revit application.
Don't know if there is a way to cross-reference an issue between two repos, but maybe this is supposed to go over to Dynamo's repo also.
No other third party packages are installed. Clean Dynamo and only DS installed.