Purge bucket files don't include mounting bracket

[maxim-kukushkin]

The assembly instructions indicate that it's possible to build a purge bucket with a brush holder using the materials provided in the kit. There're also custom files under STLs/PurgeBucket to accommodate the taller heatbed.

However, it doesn't include anything for mounting the purge bucket. The original extension bracket doesn't seem to be applicable to the provided architecture of Voron Trident (the photos there show a completely different gantry).

It also doesn't seems possible to find a bracket in any other available sources.

So photos or alternative STLs would be very much appreciated

[cr0Kz]

The assembly instructions indicate that it's possible to build a purge bucket with a brush holder using the materials provided in the kit. There're also custom files under STLs/PurgeBucket to accommodate the taller heatbed.

However, it doesn't include anything for mounting the purge bucket. The original extension bracket doesn't seem to be applicable to the provided architecture of Voron Trident (the photos there show a completely different gantry).

It also doesn't seems possible to find a bracket in any other available sources.

So photos or alternative STLs would be very much appreciated

I ended up using this version instead Trident mount for Decontaminator Purge Bucket & Nozzle Scrubber.

I am trying to tweak the macro now. I will reply to this issue once I figure it out.

[torndar]

About to try to print and install this. Did you get things figured out?

It looks like I should print these 3 for the LDO Voron Trident kit

• https://www.printables.com/model/174526-trident-mount-for-decontaminator-purge-bucket-nozz
• https://github.com/MotorDynamicsLab/LDOVoron2/blob/main/STLs/Purge%20Bucket/brush_holder_sheet_stop.stl
• https://github.com/VoronDesign/VoronUsers/blob/master/orphaned_mods/printer_mods/edwardyeeks/Decontaminator_Purge_Bucket_%26_Nozzle_Scrubber/STLs/purge_bucket_250mm_rev4.stl (maybe the 300mm version of this one?)

[torndar]

For the record the 3 models I linked above worked. However, the bucket was rather loose, even after putting magnets in it, so I added foam to the inner edges to pad between the bracket arm and the bucket. That seems to be working pretty well.