Converted few Extrusions to Fusion360 and STEP

NAK3DDesigns / White-Knight

White Knight Belt Printer

GNU General Public License v3.0

335 stars 82 forks source link

Converted few Extrusions to Fusion360 and STEP #37

Closed 3d-gussner closed 5 years ago

NAK3DDesigns commented 5 years ago

@3d-gussner please look again at both the heated and cold plates.. Two of the tabs on each plate are supposed to have a flattened tip. This was intentional to clear the side support brace.. Thanks

racenviper commented 5 years ago

Can I bring my files directly here? This is confusing for me. I have never used Git-Hub. I have all the extrusions done, just need to confirm the dimensions in the C-Beams

3d-gussner commented 5 years ago

@racenviper read https://github.com/NAK3DDesigns/White-Knight/issues/7#issuecomment-480613712 or

make a fork of WhiteKnight
change to Development branch
make an own branch via web github interface "Extrusions" or so
add via web interface your files to your "Extrusions" branch
create a new pull request to origin Development branch

3d-gussner commented 5 years ago

@NAK3DDesigns flattened tip added... sorry Glad you double checked it

3d-gussner commented 5 years ago

@racenviper Ops, i did the C-beam_1 and 2 as well but feel free to create your own pull request.

NAK3DDesigns commented 5 years ago

the c-beam extrusions look good but are both missing the exit hole at the top of the extrusion about 2 inches in one the far end from the large cutouts.. I'll merge the request so everyone can see the files and anyone can correct..

NAK3DDesigns commented 5 years ago

I also relocated the files to and "Extrusion templates" folder under Fusion 360. For now I would prefer to keep all the fusion files separated from the STL's.. Hope this doesn't make it too hard for everyone.