search

NARUTOfzr / Neptune_3_Pro_Plus_Max

Firmware file
180 stars 22 forks source link

M0 Gcode command does not work #93

Open WestInSpace opened 3 weeks ago

WestInSpace commented 3 weeks ago

When giving the printer the M0 geode command it doesn't work. It just ignores the command and continues printing. I know M600 works to change filament, but I want an unconditional pause for a certain amount of time rather than based on loading filament so that I can put magnets in my 3d prints.

chriskeeble commented 3 weeks ago

I have successfully used the filament change code to pause, insert nuts (magnets would work just the same) and then unpause without changing filament.

It makes no difference apart from what it says on the screen.

WestInSpace commented 3 weeks ago

Dropping magnets in was just an example. (A bad example I guess) what I actually want to do is home the toolhead then pause for a certain amount of time then home again and start the print. I want to do this to allow the inductive sensor to heat up so I can get more consistent prints and z-offset. Heat affects inductive sensors a lot, I have measured as much as 0.13mm from the bed difference between a cold and hot inductive sensor. So I want it to heat up before homing before a print. If that makes sense.

On Tue, Jun 4, 2024, 5:05 PM Chris Keeble @.***> wrote:

I have successfully used the filament change code to pause, insert nuts (magnets would work just the same) and then unpause without changing filament.

It makes no difference apart from what it says on the screen.

— Reply to this email directly, view it on GitHub https://github.com/NARUTOfzr/Neptune_3_Pro_Plus_Max/issues/93#issuecomment-2148415364, or unsubscribe https://github.com/notifications/unsubscribe-auth/BEXAVRLTYUXYOJX2UAOLEGDZFYT2BAVCNFSM6AAAAABIZGMMZ2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCNBYGQYTKMZWGQ . You are receiving this because you authored the thread.Message ID: @.***>