I'm unable to build the Engine LLB. My environment is as follows:
LabVIEW 2020 SP1
VeriStand 2020 R6
Ballard Drivers 1.3.1.1 from the NI website.
After following the directions from the User Readme.rtf (renaming files in BTI1553LV.lvlib), I get the error message:
"Error 10 occurred at New VI Library.vi
Possible reason(s):
LabVIEW: (Hex 0xA) Duplicate path."
That'a all I get. Is there a possibility of getting more in-depth log files to see exactly what went wrong?
My gues is here, that there ar still stome files with naming collisions. I renamed all of them mentioned in the readme. That was not enough - I had to rename two additional files:
BTI1553LV.lvlib/Private/Channel/Configure/Configure All From XML.vi
BTI1553LV.lvlib/Public/Controls/Error Info.ctl
I prepended a "1553 " to both files. At this point, the Build preview for the Engine LLB passes successfully presenting a "Ballard - 1553 Engine.llb", as expected. But the real build still fails.
Do you have any ideas on how to proceed from here?
I'm unable to build the Engine LLB. My environment is as follows:
LabVIEW 2020 SP1 VeriStand 2020 R6 Ballard Drivers 1.3.1.1 from the NI website.
After following the directions from the User Readme.rtf (renaming files in BTI1553LV.lvlib), I get the error message:
"Error 10 occurred at New VI Library.vi
Possible reason(s):
LabVIEW: (Hex 0xA) Duplicate path."
That'a all I get. Is there a possibility of getting more in-depth log files to see exactly what went wrong?
My gues is here, that there ar still stome files with naming collisions. I renamed all of them mentioned in the readme. That was not enough - I had to rename two additional files:
I prepended a "1553 " to both files. At this point, the Build preview for the Engine LLB passes successfully presenting a "Ballard - 1553 Engine.llb", as expected. But the real build still fails.
Do you have any ideas on how to proceed from here?
Regards,
Sebastian