search

NSPManager / NSPanelManager

Sonoff NSPanel custom firmware for responsive and intuitive use
https://nspanelmanager.com/
128 stars 10 forks source link

All lights mode does not work properly #44

Closed cablesandcoffee closed 11 months ago

cablesandcoffee commented 1 year ago

Action: Pressing button to change from Room Lights mode to All Lights mode.

After this it is only the first ON-press on either table or ceiling lights that have an effect on all lights. OFF press does not work the first time at all. After this the only lights effected by either OFF or ON press on ceiling or table are the lights in the room that the first page of the panel was on when All Lights mode was entered.

So if having the panels first page set to Bathroom, then entering all lights mode. All lights will turn on on the first press of ceiling or table lights buttons. After that the following ON/OFF presses only effect bathroom lights.

Panel does not seem to go back to Room Lights mode after entering screen saver either.

tpanajott commented 1 year ago

Have this been tested again in recent releases?

cablesandcoffee commented 11 months ago

Yes it has, closing!