AnyBeam HAT to OE Sensor FPC Connector/Housing Specs Please.

NebraLtd / AnyBeam

Resources for the Nebra AnyBeam laser pico projectors

34 stars 6 forks source link

AnyBeam HAT to OE Sensor FPC Connector/Housing Specs Please. #16

Closed pixma closed 3 years ago

pixma commented 3 years ago

Can I have the spec of the FPC connector where the FPC Cable is used to connect the HAT and the Mems Lase Sensor Module? If yes, I would like to know more about the connector's

Pitch?
Top Contact or Bottom Contact?
Positions: 30 | OK
Voltage Rating

and so on and so forth, of the FPC Connector. So we can choose the FPC Connector correctly to take in the FPC Cable which comes out from OE Mems Sensor Module Itself.

Regards,

shawaj commented 3 years ago

Pinout diagram for it.

pixma commented 3 years ago

Hi,

Thank you @shawaj for the pinout description, but, I am looking for something like this, if you can confirm if it is 0.5mm pitch bottom contact FPC Connector. Or if the PFC connector has some other spec?

(The above image is a sample to show only)

shawaj commented 3 years ago

@pixma ah yes sorry should have said I'll have that detail for you soon

pixma commented 3 years ago

Hi,

I am looking forward to that info. It's important info/ Hence, this is a gentle reminder @shawaj or anyone who have this info, can you please share when you can.

Regards

shawaj commented 3 years ago

20201224_012442

So it's 30 pin and 0.5mm pitch

shawaj commented 3 years ago

@pixma was that what you needed?

pixma commented 3 years ago

Thank you @shawaj , yes this information is good enough to select the mating connector.

Regards.