Open MrNHQ opened 3 years ago
I'm also interested in this
Same here.
Das kann ich machen. Bis wann braucht ihr die Zeichnungen? Im besten Fall kann ich es morgen anfertigen. Habt ihr eine Maßgabe hinsichtlich der Radii?
Viele Grüße Benedict
Am Di., 26. Apr. 2022 um 14:09 Uhr schrieb @.***>:
Liebes UC2 Team,
aus Sicherheitsgesichtspunkten bitte ich um eine Änderung der Laserzuschnitteile aus 3mm Acryl.
Grundsätzlich sollten alle Teile an den Außenkanten einen Radius haben und keine rechtwinkeligen Kanten. Das kann einfach zu Verletzungen führen.
Könnt ihr das noch machen? Oder soll LABmaker für die Fertigungsserie alle Schnitteile eigenständig neu erstellen?
Viele Grüße
York
Hello,
I would like to control the settings of the projector programmatically from a raspberry pi. One option, using the anybeam HAT, could be "hacking the buttons" with transistors and resistors and connect them to an arduino. Finally, connect the arduino to the raspberry pi so that raspberry pi is the controller. I don't know if it is possible with the other type of anybeam (developer kit or production)?
Are there other easier alternatives?
Note, I do not have the anybeam HAT yet, it was out of stock. I contacted distrelec and they will receive new pieces in a week or two :).