Unable to connect dash button to wifi

[SameerPujji]

Put an x into all the boxes [ ] relevant to your issue (like this: [x])

What is the purpose of your issue?

• [ x] Bug report (encountered problems with amazon-dash)
• [ ] Feature request (request for a new functionality)
• [ ] Question
• [ ] Other

Guideline for bug reports

You can delete this section if your report is not a bug

• amazon-dash version: 1.4.0

• Python version: 2.7.16/3.7.3

• Pip & Setuptools version:

• Operating System: Raspberry Pi OS

• [ x] The pip install or setup install command has been completed without errors

• [x ] The python -m amazon_dash.install command has been completed without errors

• [ ] The amazon-dash discovery command works without errors

• [ ] I have created/edited the configuration file

• [ ] Amazon-dash service or amazon-dash --debug run works

Description

Sorry in advance, I am new to this.

I am trying to connect my new amazon dash buttons to my network after completing the hack device part (received green LED once the sound was played).

When I put y to the question "Is the blue light flashing?", 5 seconds later the blue light immediately stops flashing and then nothing happens. A few seconds after this, I get the error Timeout connecting to network.

If I am connected to any network (either my home network or the Amazon ConfigureMe network), I get the following error message:

Error for wireless request "Set ESSID" (8B1A) : Set failed on device wlan0; Operation already in progress.

So I have to disconnect from any network before running the configure command.

I have tried connecting to the button's wifi network, visiting http://192.168.0.1/?amzn_ssid=&amzn_pw= but again, as soon as I visit this web page the button immediately stops blinking and turns off

[SameerPujji]

It turns out even though the device is shutting off when trying to connect to wifi, the process is completing successfully. The CLI isn't working for me, but visiting the URL/IP address above seems to configure the device correctly.