With the new firmware the the bluetooth dyio that was working is no longer working. I need some electrical taps to debug this.
First, the DyIO and a 2 port serial adapter needs to be mounted to a board (yes i do mean first, and yes i am serious about it needing to be mounted)
the 2 serial pins comming out of the DyIO/bt need to go into the respective RX pins of the adapter. the output of this modified dyio should be 2 bowler serial cables.
the 3 control lines need to be pulled to pin headers, those headers need to be mounted as well
also i need a programming header soldered to the DyIO so i can step through it with the debugger. This should be the same sort of module i used to use for the serial dyio development.
With the new firmware the the bluetooth dyio that was working is no longer working. I need some electrical taps to debug this.
First, the DyIO and a 2 port serial adapter needs to be mounted to a board (yes i do mean first, and yes i am serious about it needing to be mounted)
the 2 serial pins comming out of the DyIO/bt need to go into the respective RX pins of the adapter. the output of this modified dyio should be 2 bowler serial cables.
the 3 control lines need to be pulled to pin headers, those headers need to be mounted as well