Active curve point not highlighted

[GoogleCodeExporter]

Multi-point curves are very welcome, but unless the active point is highlighted 
as the stick(s) are moved, their utility is severely limited.

I note that it's possible to edit a curve directly from the Edit Mix screen (by 
long press on the CURVE field). Presumably the mixer context could be passed to 
the curve screen? In that case, would it not be possible to use data to 
highlight the active point as the appropriate sticks (for that mixer context) 
are moved?

IMO this is the one single feature which may prevent some pilots from switching 
to the Taranis for F3X, as we use multi-point curves in the field for adjusting 
elevator compensation. Highlighting curve points in response to stick movement 
is essential for this.

Which board (stock / gruvin9x / sky9x / Taranis) are you using?
Taranis

What is your openTx FW version?
r2588

What is your openTx EEPROM version?
215

What steps will reproduce the problem?
1. Open the Edit Mix screen on a mix line which uses a Curve 
2. Tab to the Curve field, and press Long Enter to open the Curve screen

Original issue reported on code.google.com by m.shel...@gmail.com on 17 Jul 2013 at 10:22

[GoogleCodeExporter]

Original comment by bernet.a...@gmail.com on 17 Jul 2013 at 10:52

• Changed state: Accepted
• Added labels: Type-Enhancement
• Removed labels: Type-Defect

[GoogleCodeExporter]

Issue 187 has been merged into this issue.

Original comment by bernet.a...@gmail.com on 25 Nov 2013 at 1:33